Navitas 600AMP Shunt Wound Controller for EZ-GO ITS Carts.
Fits EZ-GO ITS Electric Models with Curtis 1268/1264 controllers.
DOES NOT FIT EZ-GO WITH ANY OTHER CONTROLLER TYPE.
Pre Purchase Checklist:
Cart must have a Curtis 1268/1264 Controller.
Heavy duty solenoid (required for controllers 440 amps or higher)
If you have a Lithium battery check your battery discharge specification to in sure the battery can handle the amperage Navitas controllers call for. Insufficient amperage ratings will call for the controller amperage to be turned down. 440 amp controller should have a 400 amp output battery. 600 amp controllers should have a 500 - 600 amp output battery.
Carts with lead acid batteries should have heavy duty batty cables. 4 Gauge or bigger cables.
600AMP TSX 3.0 Second Generation Golf Cart Controller
Personality Module that plugs directly into your existing wiring harness'
On-The-Fly Programmer Dashmountable for near instant performance tuning while on the Road or Trail
Compact Lightweight Design for Easy installation
Increases stock Performance in both Speed (19-22MPH) and Torque Power (up to 40%) in certain configurations
Utilizes Stock Golf Cart Motor, Solenoid and Wiring
Built in Thermal Protection
Speed Sensor Input
Adjustable Regenerative Braking and Motor Reversing
Bluetooth Connectivity with downloadable Navitas IOS and Android App
Personalize the driving experience with Navitas On-The-Fly Programmer.
Adjust for More Speed or More Range
Set the level of Regenerative Braking
Control Rate of Acceleration
Key Lock to lock in the settings, disable the dials and allow physical removal of the programmer
Diagnostics - LED is used to signal state change and diagnostic information to the operator.